Suzuki Sidekick

Defect: VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. INSUFFICIENT STRENGTH OF THE MOUNTING BASE ON THE UPPER END OF THE FRONT STRUTS CAN LEAD TO BREAKAGE OF THE MOUNTING BOLTS THAT ATTACH THE UPPER END OF THE FRONT STRUTS TO THE VEHICLE BODY.

Risc: IF THE STRUT BROKE LOOSE, A DRIVER COULD LOSE CONTROL OF THE VEHICLE, INCREASING THE RISK OF A CRASH.

Remediul producătorului: DEALERS WILL ADD A REINFORCEMENT, FOR BOTH FRONT STRUTS, BETWEEN THE FRONT STRUT MOUNTING BASE AND THE VEHICLE BODY. IN ADDITION, THE FRONT STRUT MOUNTING BASES, MOUNTING BOLTS AND NUTS, AND STRUT BAR STAYS WILL BE REPLACED.

Defect: THE FUEL TANK ON THESE VEHICLES CAN BECOME PUNCTURED BY A FUEL TANK FLANGE ATTACHMENT REINFORCEMENT DURING REAR-END COLLISIONS. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 301, "FUEL TANK INTEGRITY."

Risc: CONSEQUENCE OF NON-COMPLIANCE: IF AN IGNITION SOURCE WAS PRESENT, FUEL LEAKAGE RESULTING FROM THIS PUNCTURE COULD RESULT IN A POST-CRASH FIRE.

Remediul producătorului: DEALERS WILL INSTALL TWO NEW SHIELD GUSSETS BETWEEN THE FUEL TANK AND ATTACHMENT BRACKETS TO PREVENT THE REINFORCEMENT FROM PUNCTURING THE FUEL TANK WALL.

Defect: THE RIGHT REAR AND LEFT AXLE SHAFT HOUSING TUBES WERE INCORRECTLY WELDED AND CAN FRACTURE. FRACTURE OF THE REAR AXLE SHAFT HOUSING CAN RESULT IN SEPARATION OF THE AFFECTED WHEEL ASSEMBLY AND SEPARATION OF THE BRAKE LINE.

Risc: SEPARATION OF THE WHEEL ASSEMBLY CAN CAUSE LOSS OF VEHICLE CONTROL AND SEPARATION OF THE BRAKE LINE RESULTS IN LOSS OF ONE-HALF OFTHE BRAKING SYSTEM, INCREASING STOPPING DISTANCE. IN EITHER CASE, AN ACCIDENTCAN OCCUR.

Remediul producătorului: DEALERS WILL INSPECT THE WELDS OF THE REAR AXLE ASSEMBLIES ON INVOLVED VEHICLES AND, IF NECESSARY, REPLACE THE COMPLETE REAR AXLE ASSEMBLY.

Defect: THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Risc: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remediul producătorului: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.