Ford F250

Defect: COMM TRANS IS RECALLING 108 MY 2005-2008 FORD E250 AND E350 VANS BUILT ON FORD CHASSIS AND EQUIPPED WITH RICON PLATFORM STYLE WHEELCHAIR LIFTS. THESE LIFTS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 403, "PLATFORM LIFT SYSTEM ACCESSIBLE FOR MOTOR VEHICLES." THE ANTI-STOW INTERLOCK MAY NOT DETECT THE PRESENCE OF A WHEELCHAIR OR MOBILITY AID USER. THE PRESSURE SENSING SWITCH THAT DETECTS THE PRESENCE OF WEIGHT ON THE PLATFORM WAS NOT ADJUSTED TO THE NECESSARY SENSITIVITY LEVEL. THE LIFT COULD STOW EVEN THOUGH SOMEONE OR SOMETHING IS STILL ON THE LIFT.

Risc: A LIFT OCCUPANT CAN BE INJURED SHOULD THE LIFT BEGIN TO STOW UNINTENTIONALLY.

Remediul producătorului: COMM TRANS IS WORKING WITH RICON TO CORRECT THE WHEELCHAIR LIFTS FREE OF CHARGE (PLEASE SEE 07E097). OWNERS MAY CONTACT RICON AT 1-818-267-3000 OR COMM TRANS AT 901-726-9394.

Defect: COMM TRANS IS RECALLING 111 MY 2005-2008 FORD E250 AND E350 VANS BUILT ON FORD CHASSIS AND EQUIPPED WITH RICON PLATFORM STYLE WHEELCHAIR LIFTS. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 404, "PLATFORM LIFT INSTALLATIONS ON MOTOR VEHICLES." THE THRESHOLD WARNING SYSTEM MAY NOT DETECT THE PRESENCE OF A WHEELCHAIR OR MOBILITY AID USER IN A CERTAIN SPOT WITHIN THE DEFINED THRESHOLD AREA.

Risc: THE USER OF THE LIFT COULD BE INJURED SHOULD THE LIFT MOVE UNINTENTIONALLY.

Remediul producătorului: COMM TRANS IS WORKING WITH RICON TO CORRECT THE WHEELCHAIR LIFTS FREE OF CHARGE (PLEASE SEE 07E095). OWNERS MAY CONTACT RICON AT 1-818-267-3000 OR COMM TRANS AT 901-726-9394.

Defect: THE IGNITION SWITCH COULD EXPERIENCE AN INTERNAL SHORT CIRCUIT.

Risc: THIS CONDITION COULD CAUSE OVERHEATING, SMOKE, AND POSSIBLY FIRE IN THE STEERING COLUMN AREA OF THE VEHICLE.

Remediul producătorului: DEALERS WILL REPLACE THE IGNITION SWITCH.

Defect: FUEL RESERVOIR SHIELDS, THAT PROTECT THE RESERVOIR FROM CONTACT BY THE TRANSFER CASE IN CERTAIN FRONTAL IMPACTS, WERE NOT INSTALLED.

Risc: FUEL SPILLAGE IN EXCESS OF THAT PERMITTED BY FMVSS 301COULD OCCUR.

Remediul producătorului: INSTALL FUEL RESERVOIR PROTECTIVE SHIELDS.

Defect: SHIELDS ON THE FRONTS OF THE MIDSHIP MOUNTED FUEL TANKS WERE OMITTED DURING ASSEMBLY.

Risc: TRUCKS WOULD NOT COMPLY WITH 30 MPH IMPACT TEST OFFMVSS NO. 301, FUEL SYSTEM INTEGRITY.

Remediul producătorului: INSTALL FUEL TANK SHIELDS.

Defect: TRUCKS FAIL TO MEET REQUIREMENT OF FMVSS NO. 301, FUEL SYSTEM INTEGRITY, IN A 30 MPH FRONT ANGULAR BARRIER TEST IMPACT BECAUSE OF THE OMISSION OF THE NOSE SHIELD ON MIDSHIP FUEL TANK. CONSEQUENCE OF DEFECT: IN CASE OF AN ACCIDENT, FUEL SPILLAGE IN THE TRUCKS WHICH DO NOT MEET THE FMVSS INCREASES THE RISK OF A FIRE.

Remediul producătorului: INSTALL NOSE SHIELD ON THE MIDSHIP FUEL TANK. FUEL TANK.

Defect: METAL BURRS AND SHARP EDGES ON FUEL RAILS MAY HAVE DAMAGED ADJACENT O-RING SEALS DURING ASSEMBLY. THE DEFECT COULD CAUSE FUEL LEAKAGE WHEN ENGINE IS OPERATING.

Remediul producătorului: FUEL RAILS WILL BE INSPECTED FOR LEAKS, WETNESS OR SEEPAGE OF FUEL AND, IF NECESSARY, FUEL RAILS AND RELATED COMPONENTS WILL BE REPLACED WITHOUT COST TO THE OWNER.

Defect: THE INVOLVED VEHICLES WERE ASSEMBLED WITH BOLTS OF AN INCORRECT SIZE FOR ATTACHMENT OF THE FRONT ENGINE MOUNTS TO THE ENGINE. THE ENGINE MOUNT BOLTS WILL LOOSEN AND EVENTUALLY FALL OFF AND THE ENGINE MAY COME OFF ITS FRONT ENGINE MOUNTS. THIS COULD RESULT IN THE FUEL LINE BECOMING DAMAGED OR SEPARATED IN CONDITIONS SUCH AS DRIVING OVER ROUGH ROADS OR IN THE EVENT OF AN ACCIDENT.

Remediul producătorului: UPON INSPECTION, DEALER WILL REPLACE MOUNT BOLTS WITH BOLTS OF THE PROPER SIZE.

Defect: SOME OF THE INVOLVED VEHICLES MAY HAVE A DIODE IN THE ELECTRICAL FUEL PUMP CIRCUIT THAT MAY SHORT DURING ENGINE STARTING DUE TO INADEQUATE CAPACITY TO WITHSTAND CURRENT DRAW. A SHORT CIRCUIT WOULD RESULT IN NORMAL ENGINE STARTING, BUT THE PUMP WILL NOT CONTINUE TO SUPPLY THE ENGINE WITH FUEL.

Remediul producătorului: THE DEALER WILL REPLACE DEFECTIVE ELEMENT IN THE ELECTRICAL FUEL PUMP CIRCUIT WITH A NEW RELAY FEED WIRING ASSEMBLY WHICH CONTAINS A LARGER CAPACITY DIODE, FREE OF CHARGE.

Defect: ON CERTAIN VEHICLES, THE LOCK WEDGES USED TO SECURE THE AXLE BEARING NUTS TO THE AXLE HOUSING MAY FALL OUT OF POSITION, ALLOWING THE NUT TO LOOSEN. THE NUT ON THE LEFT SIDE MAY FALL OFF, ALLOWING MOVEMENT OF THE AXLE SHAFT.

Remediul producătorului: THE DEALER WILL REPLACE DEFECTIVE LOCK WEDGES WITH AN IMPROVED VERSION. WHEEL BEARINGS WILL BE INSPECTED AND ADJUSTED OR REPLACED, IF NECESSARY.

Defect: WATER SEPARATOR CANISTER MAY BE PUNCTURED IN A COLLISION. CRASH TESTS IN A 30 MPH FRONTAL COLLISION REVEALED FUEL LEAKAGE EXCEEDING THE MAXIMUM PERMITTED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".

Remediul producătorului: A PROTECTIVE SHIELD FOR THE CANISTER WILL BE INSTALLED WITHOUT CHARGE.

Defect: ON THE INVOVLED VEHICLES THE DRIVER"S SIDE AND PASSENGER"S OUTSIDE REAR VIEW MIRRORS MAY HAVE BEEN OMITTED. THIS FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 111, "REARVIEW MIRRORS".

Remediul producătorului: DEALER WILL INSTALL THE PROPER MIRRORS WITHOUT CHARGE TO OWNER. IF OUTSIDE MIRRORS HAVE ALREADY BEEN INSTALLED, OWNER HAS THE OPTION TO KEEP THEM AS IS OR HAVE THEM REMOVED AND NEW MIRRORS INSTALLED.

Defect: CERTAIN VEHICLES MAY HAVE BEEN ASSEMBLED WITHOUT THE SPECIFIED FUEL TANK SHIELD WHICH PREVENTS DIRECT CONTACT BETWEEN THE FUEL TANK AND DRIVELINE COMPONENTS. DURING A 30 MPH FRONTAL BARRIER IMPACT TEST, AS SPECIFIED IN FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY", FUEL LEAKAGE MAY OCCUR.

Remediul producătorului: VEHICLES WILL HAVE THE EXISTING SEPARATE SKID PLATE OR FUEL TANK SHIELD REMOVED (WHICHEVER WAS INSTALLED ON VEHICLE). A SPECIAL COMBINATION SKID PLATE/FUEL TANK SHIELD ASSEMBLY WILL BE INSTALLED IN ITS PLACE FREE OF CHARGE.

Defect: THE OWNER"S GUIDE MAY CONTAIN AN ERROR IN THE WHEEL LUG NUT TORQUE SPECIFICATION CHART. INCORRECT INFORMATION COULD RESULT IN IMPROPER TORQUE OF THE LUG NUTS DURING WHEEL REPLACEMENT. LUG NUTS COULD COME LOOSE DURING VEHICLE OPERATION.

Remediul producătorului: AN ADHESIVE-BACKED, REVISED PAGE WILL BE SUPPLIED TO OWNERS FOR INSERTION IN THE OWNER"S GUIDE. IN ADDITION, DEALERS WILL PROVIDE TORQUE VERIFICATION, IF ONE OR MORE WHEELS HAVE BEEN SERVICED, AT NO COST TO OWNERS.

Defect: CERTAIN VEHICLES WERE NOT EQUIPPED WITH A FRONT PROTECTIVE SHIELD FOR THE MID-SHIP FUEL TANK. THESE VEHICLES DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY". IN THE EVENT OF A FRONTAL COLLISION, EXCESSIVE FUEL SPILLAGE MAY OCCUR.

Remediul producătorului: DEALER WILL INSPECT AND, IF NECESSARY, INSTALL THE REQUIRED MID-SHIP FUEL TANK SHIELD, WITHOUT CHARGE TO OWNER.

Defect: THE INVOLVED VEHICLES WERE MANUFACTURED WITHOUT THE MIDSHIP FUEL TANK PROTECTIVE SHIELDS. AS A RESULT, THEY DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY", DUE TO EXCESSIVE FUEL SPILLAGE UPON FRONTAL IMPACT.

Remediul producătorului: THE INVOLVED VEHICLES WILL BE INSPECTED AND, IF NECESSARY, A FUEL TANK SHIELD WILL BE INSTALLED AT NO CHARGE TO OWNER.

Defect: THE WHEEL RIM DIAMETERS ON THESE VEHICLES MAY EXCEED DIMENSIONAL SPECIFICATIONS. THIS MAY CAUSE THE TIRES AND TUBES TO BE OVERSTRESSED DURING MOUNTING OR IMPROPERLY MOUNTED.

Remediul producătorului: THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE WHEELS, AND THE TIRES AND TUBES MOUNTED ON THESE WHEELS.

Defect: ON THE INVOLVED VEHICLES, LEAKAGE MAY OCCUR AT THE THREADED CARBURETOR-TO-FUEL FILTER CONNECTION ON THE SUSPECT CARBURETORS. THIS IS DUE TO AN IMPROPERLY MACHINED CARBURETOR FUEL INLET CONNECTION.

Remediul producătorului: DEALER WILL INSPECT AND, IF NECESSARY, WILL REPLACE THE CARBURETOR WITHOUT CHARGE TO OWNER.

Defect: THE INVOLVED VEHICLES WERE ASSEMBLED WITH IMPROPERLY MANUFACTURED STEERING ARM KNUCKLES. SHOULD AN IMPROPERLY MANUFACTURED STEERING ARM KNUCKLE FRACTURE AND SEPARATE, THE STEERING LINKAGE TIE ROD MAY DISENGAGE FROM THE KNUCKLE.

Remediul producătorului: THE DEALER WILL INSPECT FOR CRACKING IN THE STEERING ARM KNUCKLES ON ALL VEHICLES AND, IF NECESSARY, REPLACE THEM FREE OF CHARGE.

Defect: DIMENSIONAL DIFFERENCES IN THE 1980 VERSUS THE 1979 ASSEMBLIES MAY ALLOW THE INNER BRAKE LINING/SHOE TO MOVE OUTWARD TO A POSITION WHERE IT IS NO LONGER RETAINED IN THE SHOE SLOT WHEN THE FRONT BRAKE INNER LININGS BECOME WORN TO THE POINT OF NEEDING REPLACEMENT. THE INNER BRAKE SHOE COULD THEN WEDGE BETWEEN THE ROTOR AND SPINDLE, POSSIBLY CAUSING A SUDDEN LOCK-UP OF ONE FRONT WHEEL. THIS CAN OCCUR WITHOUT BRAKE APPLICATION AND WOULD ADVERSELY AFFECT STEERING CONTROL. THESE DIMENSIONAL DIFFERENCES COULD ALSO ALLOW ADDITIONAL TRAVEL OF THE BRAKE PISTON SUCH THAT A LOSS OF BRAKE FLUID FROM THE FRONT BRAKE SYSTEM MAY OCCUR. THIS WOULD RESULT IN INCREASED STOPPING DISTANCES.

Remediul producătorului: THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE HUB AND ROTOR ASSEMBLIES AND SPINDLE SEALS.