Ford Bronco Ii

Defect: ALUMINUM WHEELS MAY HAVE BEEN INSTALLED WITH IMPROPER LUG NUTS.

Risc: WHEEL COULD BECOME LOOSE OR EVEN SEPARATE FROM THE HUBAND AXLE ASSEMBLY WHILE THE VEHICE IS IN MOTION.

Remediul producătorului: CHANGE TAPERED STYLE LUG NUTS TO SHORT SHANK STYLE LUG NUTS.

Defect: WIRING FOR THE POWER LUMBAR SEAT SYSTEM WAS ROUTED DIRECTLY BENEATH THE SEAT CUSHION SPRINGS AND MAY BE ABRADED BY THE SPRINGS.

Risc: THIS COULD RESULT IN A SHORT CIRCUIT WHICH MAY CREATESUFFICIENT HEAT TO START A FIRE IN THE SEAT CUSHION PAD AND/OR TRIM COVER.

Remediul producătorului: INSTALL A FUSE WITHIN THE POWER LUMBAR ELECTRICAL CIRCUIT.

Defect: THE ELECTRONIC ENGINE CONTROL WIRING HARNESS INSULATION MAY BE DAMAGED DUE TO COPPER SPIKES PRODUCED DURING THE WELDING OF ITS WIRES. THIS CREATES A POTENTIAL FOR A SHORT CIRCUIT BETWEEN THE WIRES WHICH ENERGIZE THE FUEL PUMP, CAUSING SOME FUEL INJECTORS TO OPEN, DISCHARGING FUEL INTO THE ENGINE. CONSEQUENCE OF DEFECT: FUEL DISCHARGED INTO THE ENGINE WOULD EVENTUALLY LEAK THROUGH THE EXHAUST SYSTEM TO THE GROUND. THIS COULD RESULT IN A FIRE IF A SOURCE OF IGNITION IS PRESENT.

Remediul producătorului: REPAIR WIRING HARNESS, CHECK ENGINE AND CATALYST FOR DAMAGE.

Defect: COMPONENTS IN THE LOCKING HUBS WERE IMPROPERLY HEAT-TREATED AND MAY CRACK OR FRACTURE UPON ENGAGEMENT OF THE FRONT DRIVE AXLES. THE BROKEN COMPONENT ON THE LEFT FRONT WHEEL MAY BECOME JAMMED AGAINST THE NUT.

Remediul producătorului: CAM ASSEMBLIES IN FRONT WHEEL AUTOMATIC LOCKING HUBS WILL BE REPLACED.