BMW M3

Defect: BMW of North America, LLC (BMW) is recalling certain model year 2000 323i sedans, coupes, convertibles, and Sports Wagons; 2000 328i sedans and coupes; 2001-2005 325i sedans, coupes, convertibles, and Sport Wagons; 2001-2005 325xi sedans and Sports Wagons; 2006 325i coupes and convertibles; 2001-2006 330i sedans, coupes, and convertibles; 2001-2005 330xi sedans; and 2001-2006 M3 coupes and convertibles to address a safety defect in the passenger side frontal air bag which may produce excessive internal pressure that could cause the air bag inflator to rupture upon deployment of the air bag.

Risc: In the event of a crash necessitating deployment of the passenger's frontal air bag, excessive internal pressure could cause rupturing of the inflator resulting in metal fragments striking and potentially seriously injuring the passenger seat occupant or other occupants.

Remediul producătorului: Owners are advised not to drive their vehicles until they have been repaired. BMW will notify owners, and dealers will replace the passenger side frontal air bag, free of charge. An interim notice was mailed to owners in September 2014. A second notice was mailed when an adequate supply of parts became available, on December 1, 2014. Owners may contact BMW customer service at 1-800-525-7417 or email BMW at CustomerRelations@bmwusa.com.

Defect: BMW of North America, LLC (BMW) is recalling certain 2021 330i, 330i xDrive, M340i, M3, and 330e xDrive vehicles. The bolt securing the seat belt assembly to the frame was not tightened to specification.

Risc: An improperly installed seat belt assembly may not restrain an occupant as expected, increasing the risk of injury.

Remediul producătorului: BMW will notify owners, and dealers will inspect the front seat belt buckle assembly connection and, if necessary, replace it, free of charge. Owner notification letters were mailed on June 25, 2021. Owners may contact BMW customer service at 1-800-525-7417.

Defect: BMW of North America, LLC (BMW) is recalling certain 2016-2017 BMW M3 Sedans, 2016-2017 BMW M4 and M4 GTS Coupes and 2017 BMW M4 Convertible vehicles. The connection between the driveshaft and the flange may fail resulting in a loss of propulsion.

Risc: A loss of vehicle propulsion can increase the risk of a crash.

Remediul producătorului: BMW will notify vehicle owners, and dealers will replace the driveshaft, free of charge. The recall began April 9, 2019. Owners may contact BMW customer service at 1-800-525-7417.

Defect: BMW North America, LLC (BMW) is recalling certain model year 2016 BMW M2 Coupe vehicles, 2015-2017 M3 Sedan vehicles and 2015-2016 M4 Coupe and M4 Convertible vehicles. During servicing of the rear differential for a prior service action, the rear sub-frame bolts may have been reused instead of being replaced. Reuse of the existing bolts may cause the bolts to loosen.

Risc: Loose rear sub-frame bolts may adversely affect vehicle handling and control, increasing the risk of a crash.

Remediul producătorului: BMW will notify owners, and dealers will replace the rear sub-frame bolts with new bolts, free of charge. The recall began on November 3, 2016. Owners may contact BMW customer service at 1-800-525-7417.

Defect: BMW of North America, LLC (BMW) is recalling certain model year 2015-2016 M3 Sedan vehicles manufactured May 30, 2015, to September 2, 2015, 2016 M4 Coupe vehicles manufactured July 3, 2015, to September 11, 2015, and 2015-2016 M4 Convertible vehicles manufactured May 29, 2015, to August 4, 2015. The affected vehicles have a driveshaft with a slip-joint that may not have been filled with grease. As a result, the slip-joint may fail over time.

Risc: If the slip-joint fails, there would be a loss of power to the rear axle and therefore the vehicle would stop moving, increasing the risk of a crash.

Remediul producătorului: BMW will notify owners, and dealers will inspect the driveshaft, replacing it as necessary, free of charge. The recall began on January 14, 2016. Owners may contact BMW customer service at 1-800-525-7417.

Defect: BMW IS RECALLING 2,500 MY 2008-2009 M3 PASSENGER VEHICLES WITH AN OPTIONAL DOUBLE CLUTCH TRANSMISSION. THE PROBLEM INVOLVES THE DOUBLE CLUTCH GEARBOX. IN A SITUATION OF RAPID VEHICLE DECELERATION, THE TRANSMISSION SOFTWARE MAY PERFORM A MULTISTAGE DOWNSHIFT.

Risc: IN THAT SITUATION, AT LOW VEHICLE SPEEDS, IT IS POSSIBLE FOR THE ENGINE TO STALL INCREASING THE RISK OF A CRASH.

Remediul producătorului: DEALERS WILL REPROGRAM THE ENGINE AND TRANSMISSION ELECTRONIC CONTROL UNIT WITH UPDATED SOFTWARE FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 3, 2008. OWNERS MAY CONTACT BMW AT 1-800-831-1117.

Defect: BMW of North America, LLC (BMW) is recalling certain 2009 328i and 328xi, 2009-2011 335d, 2008-2012 M3 Coupe and M3 Convertible, and 2008-2011 M3 Sedan vehicles. The connection of the positive battery cable at the fuse box terminal may degrade, resulting in an intermittent loss of electrical power.

Risc: A loss of electrical power can cause the vehicle to stall, increasing the risk of a crash.

Remediul producătorului: BMW will notify owners, and dealers will replace and secure the positive battery cable connector, free of charge. The recall began August 14, 2019. Owners may contact BMW customer service at 1-800-525-7417. Note: This recall is an expansion of a previous recall, number 18V-314.

Defect: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE TWO SCREWS THAT SECURE THE PARKING BRAKE CABLE MOUNTING BRACKET TO THE BACKING PLATE WERE NOT TIGHTENED PROPERLY. AS A RESULT, THE SCREWS COULD LOOSEN AND EVENTUALLY FALL INTO THE PARKING BRAKE DRUM.

Risc: IF THIS WERE TO HAPPEN, THE CABLE MOUNTING BRACKET WOULD NO LONGER BE FIXED TO THE BACKING PLATE AND THE PARKING BRAKE COULD NO LONGER BE APPLIED ON THAT SIDE OF THE VEHICLE. IT IS ALSO POSSIBLE THAT A SCREW COULD LODGE WITHIN THE PARKING BRAKE DRUM, IMPAIRING THE FREE MOVEMENT OF THE DRUM. THIS WOULD PRODUCE NOISE, AND COULD CAUSE THE PARKING BRAKE ON THAT SIDE TO LOCK UP WHILE DRIVING.

Remediul producătorului: DEALERS WILL REPLACE THE PARKING BRAKE CABLE ATTACHING SCREWS AND SECURE THEM WITH THE PROPER TORQUE. OWNER NOTIFICATION BEGAN OCTOBER 4, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117.

Defect: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THESE VEHICLES ARE BUILT WITH A SIDE AIR BAG SYSTEM CONSISTING OF DOOR-MOUNTED THORAX AIR BAGS (REAR DOOR AIR BAGS ARE OPTIONAL), A CENTRAL ELECTRONIC SENSOR AND DIAGNOSTIC SYSTEM, LEFT AND RIGHT SATELLITE IMPACT SENSORS, AND ASSOCIATED WIRING. THIS SYSTEM IS UNDULY SENSITIVE TO CERTAIN NON-CRASH IMPACTS, SUCH AS CONTACTING LARGE POTHOLES OR CURBS AT SUBSTANTIAL SPEED.

Risc: THIS COULD CAUSE THE SIDE AIR BAG TO DEPLOY WITHOUT AN ACTUAL SIDE CRASH. IN ADDITION, THE BATTERY SAFETY TERMINAL (BST) COULD ALSO ACTIVATE, DISCONNECTING THE STARTER CABLE FROM THE BATTERY. IN THIS CASE, THE VEHICLE'S ELECTRICAL SYSTEM COULD CONTINUE TO OPERATE AND THE ENGINE WOULD CONTINUE TO RUN, BUT AFTER STOPPING, COULD NOT BE RESTARTED.

Remediul producătorului: DEALERS WILL REPROGRAM THE CENTRAL COMPUTER CONTROL MODULE THAT REGULATES THE PERFORMANCE OF ALL OF THE VEHICLE'S OCCUPANT PROTECTION SYSTEMS.

Defect: IN A FMVSS NO. 208 30 MILES-PER-HOUR COMPLIANCE TEST, AN UNBELTED TEST DRIVER DUMMY'S CHEST MAXIMUM RESULTANT ACCELERATION WAS 70.8 G'S, WHICH EXCEEDS THE MAXIMUM ALLOWABLE VALUE OF 60 G'S. ALSO, THE UNBELTED PASSENGER DUMMY'S LEFT FEMUR MAXIMUM LOAD WAS 2361 LBS, WHICH EXCEEDS MAXIMUM ALLOWABLE VALUE OF 2250 LBS. THE VEHICLES DO NOT COMPLY WITH FMVSS NO. 208, "OCCUPANT CRASH PROTECTION."

Risc: CONSEQUENCE OF NON-COMPLIANCE: IN THE EVENT OF AN ACCIDENT, THE OCCUPANT WILL BE SUBJECTED TO AN INCREASED RISK OF INJURY.

Remediul producătorului: ON AUTOMATIC TRANSMISSION MODELS ONLY, THE DEALER WILL REPLACE THE TRANSMISSION SUPPORT CROSSMEMBER WITH A CROSSMEMBER USED ON THE MANUAL TRANSMISSION MODEL. ALSO, THE TRANSMISSION REAR BUSHING SUPPORTS WILL BE REPLACED WITH BUSHING HAVING DIFFERENT PERFORMANCE CHARACTERISTICS. THE STEERING COLUMN FRONT SUPPORT BEARING AT THE FIREWALL WILL BE REPLACED WITH A MODIFIED PART USING A TEFLON INNER SURFACE AND TEFLON SPRAY WILL BE APPLIED TO THE COLUMN HOUSING IN THE AREA OF THE BEARING. A BRACE WILL BE ADDED BETWEEN THE KNEE BOLSTER SUPPORT AND THE STEERING COLUMN.