Ford Probe

Difetto: VEHICLE DESCRIPTION: PASSENGER VEHICLES. AN EXTERNAL SPRING IN THE TIMING BELT TENSIONER CAN BREAK AND GET CAUGHT IN THE TIMING BELT.

Rischio: THIS CONDITION CAN RESULT IN POSSIBLE ENGINE STALLING.

Rimedio del costruttore: DEALERS WILL INSPECT THE TENSIONER AND REPLACE IT IF NECESSARY.

Difetto: THE SUPPLEMENTARY AIR BAG INFLATABLE RESTRAINT CAUTION LABEL LOCATED ON THE DRIVER SIDE SUN VISOR DOES NOT CONTAIN THE STATEMENT, "DO NOT INSTALL REARWARD FACING CHILD SEATS IN ANY FRONT PASSENGER SEAT POSITION." THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION."

Rischio: CONSEQUENCE OF NON-COMPLIANCE: OPERATORS COULD FAIL TO NOTICE AND HEED THE WARNING LABEL.

Rimedio del costruttore: A NEW CAUTION LABEL, WITH INSTALLATION INSTRUCTIONS, WILL BE SENT DIRECTLY TO OWNERS. OWNERS CAN INSTALL THE LABEL OR, IF THEY WISH, CAN HAVE THEIR DEALER INSTALL THE LABEL FOR THEM.

Difetto: THE PASSENGER SIDE AIR BAG HAS AN INFLATOR BODY THAT CRACKED DURING FORMING OF THE CURL THAT RETAINS THE IGNITER PLUG IN THE END OF THE INFLATOR. ALSO THE IGNITER END CAP CAN SEPARATE FROM THE INFLATOR.

Rischio: THE PASSENGER SIDE AIR BAG MAY NOT INFLATE PROPERLY RESULTING IN REDUCED OCCUPANT PROTECTION IN A VEHICLE ACCIDENT. IF THE IGNITER END CAP SEPARATES IN A FRONTAL COLLISION, HOT GASES CAN BE RELEASED AND IGNITE FLAMMABLE MATERIAL OR CAUSE BURN INJURIES.

Rimedio del costruttore: DEALERS WILL REMOVE AND REPLACE THE PASSENGER SIDE AIR BAG MODULE.

Difetto: IF THE PASSENGER-SIDE AIR BAG DEPLOYS IN AN ACCIDENT AND THERE IS NO PASSENGER IN THAT SEATING POSITION, THE AIR BAG CAN DETACH FROM, AND DEFORM, THE MOUNTING BRACKET.

Rischio: INSTALLATION OF A REPLACEMENT PASSENGER-SIDE AIR BAGWOULD BE IMPEDED BY THE DAMAGE TO THE MOUNTING BRACKET AND WOULD REQUIRE MOREEXPENSIVE REPAIR WORK. THIS MAY DETER THE VEHICLE OWNER FROM HAVING THE REPAIRMADE AND THE REPLACEMENT AIR BAG INSTALLED, WHICH WOULD PLACE FUTURE PASSENGERSAT HIGHER RISK OF INJURY IN AN ACCIDENT.

Rimedio del costruttore: A NEW AIR BAG MODULE WITH A SLIGHTLY REVISED DOOR TO IMPROVE FIT AND APPEARANCE WILL BE INSTALLED AND A DOUBLER WILL BE INSTALLED ON THE MOUNTING BRACKET TO MORE SECURELY RETAIN THE MODULE.

Difetto: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE LOWER PIVOT PIN THAT JOINS THE LIFTGATE GAS STRUT TO THE BODY CAN SEPARATE FROM THE LOWER STRUT MOUNTING BRACKET DUE TO AN UNDERSIZED RIVET HEAD.

Rischio: PIVOT PIN SEPARATION CAUSES THE LIFTGATE TO DESCEND SUDDENLY, RESULTING IN AN INJURY IF SOMEONE IS STRUCK BY THE LIFTGATE.

Rimedio del costruttore: REPLACE LIFTGATE STRUT ASSEMBLIES HAVING UNDERSIZED PIVOT PIN RIVET HEAD DIAMETERS WITH ASSEMBLIES WITH ADEQUATE PIVOT PIN RIVET HEADS.

Difetto: CERTAIN SPX FILTRAN FUEL FILTERS WITH A 45-DEGREE ANGLE INLET TUBE, MODEL 800F350-S1, SOLD AS REPLACEMENT FILTERS FOR 1993-1997 FORD PROBE,1993-2001 MAZDA 626 AND MX-6, AND 1983-1994 LOYAL, 3-DOOR COUPE, HATCHBACK, SEDAN, WAGON, BRAT, DL, GL, GL-10, RX, XT, AND XT6 PASSENGER VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. CERTAIN SPX FILTRAN FUEL FILTERS WITH A 90-DEGREE ANGLE INLET TUBE, MODEL 800F300-S2, SOLD AS REPLACEMENT FILTERS FOR 19983-1994 SUBARU VEHICLES WITH EFI OR TURBO ENGINES. THESE FILTERS ARE PACKAGED AS WIX, NAPA, AND CARQUEST BRAND FUEL FILTERS. FUEL MAY LEAK FROM THE FILTER DUE TO NON-CONFORMING BRAZING WELDS WHERE THE INLET TUBE IS CONNECTED TO THE FILTER CAN.

Rischio: IN THE PRESENCE OF AN IGNITION SOURCE, A VEHICLE FIRE CAN OCCUR.

Rimedio del costruttore: SPX WILL NOTIFY ITS CUSTOMERS AND PROVIDE A FULL REFUND. THE RECALL BEGAN SEPTEMBER 27, 2005. OWNERS MAY CONTACT MR. CHRIS GREESON AT 704-869-3733 OR CONTACT THE WIX INFORMATION HOTLINE AT 800-949-6698.

Difetto: NOTE: DRIVER'S SIDE (LEFT) PASSIVE SEAT BELT ASSEMBLY. THE RAIL OF THE AUTOMATIC SHOULDER BELT CAN WEAR SUFFICIENTLY SUCH THAT THE CABLE WHICH RETRACTS THE BUCKLE ASSEMBLY WILL BECOME JAMMED IN THE RAIL RENDERING THE SHOULDER BELT INOPERATIVE.

Rischio: IN THE EVENT OF A VEHICLE CRASH, THE OCCUPANT WOULD NOT BE ADEQUATELY RESTRAINED INCREASING THE RISK OF PERSONAL INJURY.

Rimedio del costruttore: DEALERS WILL REPLACE DRIVER SIDE AND INOPERATIVE PASSENGER SIDE SHOULDER BELT TRACK ASSEMBLIES.

Difetto: BRACKETS MOUNTING AUTOMATIC SHOULDER BELT RETRACTOR ASSEMBLY MAY HAVE AN UNDERSTRENGTH SPOT WELD.

Rischio: SHOULDER BELT COULD FAIL IN A COLLISION INCREASING THERISK OF INJURY TO THE OCCUPANT.

Rimedio del costruttore: INSTALL TWO BOLTS IN THE BRACKETS TO PREVENT SHOULDER BELT FAILURE.

Difetto: THROTTLE LEVERS MAY HAVE BEEN BENT DURING ASSEMBLY.

Rischio: THROTTLE MAY STICK AND NOT RETURN FULLY TO IDLEPOSITION.

Rimedio del costruttore: PLACE AFFECTED VEHICLES ON DELIVERY HOLD UNTIL REPAIRED.

Difetto: NOTE: PASSENGER SIDE (RIGHT) SEAT BELT ASSEMBLY. THE RAIL OF THE AUTOMATIC SHOULDER BELT CAN WEAR SUFFICIENTLY SUCH THAT THE CABLE WHICH RETRACTS THE BUCKLE ASSEMBLY WILL BECOME JAMMED IN THE RAIL RENDERING THE SHOULDER BELT INOPERATIVE.

Rischio: IN THE EVENT OF A VEHICLE CRASH, THE OCCUPANT WOULD NOT BE ADEQUATELY RESTRAINED INCREASING THE RISK OF PERSONAL INJURY.

Rimedio del costruttore: DEALERS WILL REPLACE DRIVER SIDE AND INOPERATIVE PASSENGER SIDE SHOULDER BELT TRACK ASSEMBLIES.