Ford Crown Victoria

Difetto: Ford Motor Company (Ford) is recalling certain model year 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles manufactured October 3, 2001, to August 2, 2005. The affected vehicles have a lighting control module (LCM) that may fail, resulting in a loss of headlights.

Rischio: A loss of headlights can reduce driver visibility and increase the risk of a crash.

Rimedio del costruttore: Ford will notify owners, and dealers will replace the LCM, free of charge. The recall began April 14, 2017. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 15S39.

Difetto: ON CERTAIN NATURAL GAS MODEL VEHICLES, A T-FITTING THAT CONNECTS FUEL TANKS #3 AND #4 CAN DEVELOP A LEAK WHEN THE SOLENOID VALVES ARE ENERGIZED, SUCH AS WHEN THE IGNITION SWITCH IS IN THE ON POSITION OR DURING REFUELING.

Rischio: A GAS LEAK OF SUFFICIENT QUANTITY CONCENTRATED IN AN AREA TO CREATE A COMBUSTIBLE MIXTURE AND IN THE PRESENCE OF AN IGNITION SOURCE COULD RESULT IN A FIRE.

Rimedio del costruttore: DEALERS WILL INSTALL A REDESIGNED "T" FITTING ON #4 FUEL TANK AND TESTED FOR LEAKAGE. OWNER NOTIFICATION BEGAN SEPTEMBER 13, 2002. OWNERS WHO DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-866-436-7332.

Difetto: VEHICLE DESCRIPTION: PASSENGER VEHICLES USING AFTERMARKET DRIVER'S SEAT BELT ASSEMBLIES THAT WERE SOLD BY FORD PARTS DEPARTMENTS FROM JANUARY 1, THROUGH JUNE 13, 2000. THESE SEAT BELT ASSEMBLIES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 209, "SEAT BELT ASSEMBLIES." THE EQUIPMENT INVOLVED IS SERVICE STOCK SEAT BELT ASSEMBLIES, MODEL NOS. H 9977, H 9979, T 9063, AND T 9217, BUILT BY TRW VEHICLE SAFETY SYSTEMS, INC. (TRW) MANUFACTURED FROM JUNE 1, 1998 THROUGH MAY 21, 2000. SOME OF THESE SEAT BELT ASSEMBLIES MAY HAVE BEEN INSTALLED AS SERVICE REPLACEMENT EQUIPMENT ON THE VEHICLES INVOLVED IN THE RECALL.

Rischio: IN THE EVENT OF A COLLISION, THESE SEAT BELTS MAY NOT RESTRAIN AN OCCUPANT INCREASING THE RISK OF INJURY.

Rimedio del costruttore: DEALERS WILL INSPECT THESE VEHICLES AND REPLACE THE SERVICE SEAT BELT ASSEMBLIES THAT WERE INSTALLED IN THESE VEHICLES FROM JANUARY 1 THROUGH JUNE 13, 2000.

Difetto: VEHICLE DESCRIPTION: A WINDSHIELD WIPER CONTROL MODULE MAY NOT BE CAPABLE OF CARRYING THE CURRENT REQUIRED DURING HIGH LOAD CONDITIONS ON THE WIPERS (I.E., ICE, SNOW, OR OTHER DEBRIS).

Rischio: THIS CONDITION COULD RESULT IN INOPERATIVE WIPERS WITH NO ADVANCE WARNING.

Rimedio del costruttore: DEALERS WILL INSPECT THE WIPER CONTROL MODULES AND REPLACE IF NECESSARY.

Difetto: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THESE VEHICLES HAVE JACKING INSTRUCTIONS WHICH, IF FOLLOWED, COULD CAUSE THE VEHICLE OPERATOR TO PLACE THE JACK ON A FRAME WELD WHEN ATTEMPTING TO RAISE A REAR WHEEL. IF THE VEHICLE IS JACKED UP WITH THE JACK PLACED ON THE FRAME WELD AND IF THE VEHICLE IS FREE TO ROLL (WHEELS NOT BLOCKED OR CHOCKED), THE JACK COULD YIELD AND THE VEHICLE MAY DROP SUDDENLY.

Rischio: IF THIS OCCURS AND ANY PORTION OF THE OPERATOR'S BODY IS UNDER THE VEHICLE, THE POTENTIAL FOR PERSONAL INJURY EXISTS.

Rimedio del costruttore: OWNERS WILL BE PROVIDED WITH A REVISED JACK INSTRUCTION AND STOWAGE CARD AND JACK WARNING LABEL, AS WELL AS A SUPPLEMENT TO THE OWNER GUIDE.

Difetto: IN ORDER TO ENHANCE POLICE OFFICE SAFETY, MODEL YEAR 1992-2003 CROWN VICTORIA POLICE INTERCEPTOR (CVPI) VEHICLES WILL BE EQUIPPED WITH SHIELDS DESIGNED TO HELP PROTECT THE FUEL TANK IN HIGH-SPEED REAR-IMPACT CRASHES. FORD ALSO WILL BE OFFERING AN OPTIONAL TRUNK PACKAGE DESIGNED TO IMPROVE THE SAFE TRANSPORT OF SHARP-EDGED, HEAVY EQUIPMENT IN THESE VEHICLES.

Rischio: SOME HIGH-SPEED REAR-IMPACT CRASHES HAVE RESULTED IN FUEL TANK PUNCTURES AND FIRES IN CVPI VEHICLES.

Rimedio del costruttore: FORD HAS ADVISED US THAT SHIELD KITS HAVE BEEN AVAILABLE SINCE LATE OCTOBER AND WILL BE INSTALLED ON POLICE INTERCEPTOR VEHICLES AT NO COST. THE OPTIONAL TRANK PACKAGE WILL BE AVAILABLE BY THE END OF 2002. FORD HAS ESTABLISHED A NEW WEB SITE AT WWW.CVPI.COM TO ANSWER ADDITIONAL QUESTIONS ABOUT THE SAFE USE OF CPVI VEHICLES.

Difetto: WHEN IN THE SECONDARY LATCHED POSITION, THE DRIVER DOOR LATCHES MAY OPEN WHEN SUBJECTED TO TRANSVERSE LOADS LESS THAN THAT SPECIFIED IN FMVSS NO. 206, "DOOR LOCKS AND DOOR RETENTION COMPONENTS."

Rischio: THE DRIVER'S DOOR, WHEN CLOSED ONLY TO THE SECONDARY LATCHED POSITION, MAY NOT SUSTAIN A 1,000 POUND TRANSVERSE LOAD.

Rimedio del costruttore: DEALERS WILL INSPECT AND, IF NECESSARY, REPLACE THE DRIVER DOOR LATCH.

Difetto: ON CERTAIN NATURAL GAS VEHICLES, IF A FLAME FROM A VEHICLE INTERIOR FIRE BECOMES LOCALLY DIRECTED AT THE NATURAL GAS FUEL TANK LOCATED IMMEDIATELY BEHIND THE REAR SEAT, THE FLAME COULD DAMAGE THE FIBERGLASS WRAP ON THE TANK WEAKENING THE TANK.

Rischio: IF THE STRENGTH OF THE TANK IS SIGNIFICANTLY COMPROMISED, IT COULD RUPTURE, INCREASING THE RISK OF A FIRE.

Rimedio del costruttore: DEALERS WILL INSTALL AN INSULATOR BEHIND THE CURRENT SEAT BACK. OWNER NOTIFICATION BEGAN ON JANUARY 7, 2004. OWNERS SHOULD CONTACT FORD AT 1-800-392-3673.

Difetto: VEHICLE DESCRIPTION: POLICE AND TAXI VEHICLES. THE HOOD LATCH STRIKER CAN WEAR OR BECOME DETACHED FROM THE HOOD.

Rischio: EITHER OF THESE CONDITIONS CAN RESULT IN THE HOOD OPENING WITHOUT WARNING WHILE THE VEHICLE IS BEING OPERATED IMPAIRING THE DRIVER'S VISIBILITY.

Rimedio del costruttore: DEALERS WILL INSTALL AN IMPROVED HOOD LATCH STRIKER (VEHICLES WITH 1992 MODEL HOODS) OR REVISED STRIKER PLATE ATTACHING FASTENERS (VEHICLES WITH 1993-1997 MODEL HOODS).

Difetto: THESE VEHICLES WERE BUILT WITH THE NON-CYCLING POWER WINDOW CIRCUIT BREAKER AND THE CYCLING HEADLAMP CIRCUIT BREAKER INTERCHANGED.

Rischio: IN THE EVENT OF A SHORT OR OVERLOAD IN THE HEADLAMPCIRCUIT, BOTH HEADLAMPS CAN GO OUT WITHOUT WARNING, RATHER THAN FLASHING AS INTENDED WITH THE CYCLING CIRCUIT BREAKER. THIS COULD LEAD TO REDUCED NIGHT TIME DRIVER VISIBILITY, INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

Rimedio del costruttore: DEALERS WILL INSPECT THESE VEHICLES, REMOVE THE CIRCUIT BREAKER AND REINSTALL THE BREAKER IN THE CORRECT LOCATIONS.

Difetto: THE NUTS AND BOLTS THAT ATTACH THE REAR BRAKE ADAPTOR TO THE AXLE HOUSING FLANGE CAN LOOSEN AND EVENTUALLY SEPARATE. IF ONE OR MORE OF THE NUTS COME OFF THE BOLTS, DAMAGE TO THE PARKING BRAKE ASSEMBLY OR TO THE ANTILOCK BRAKE SYSTEM (ABS) SENSOR AND SENSOR RING (IF SO EQUIPPED) WILL OCCUR. IF ALL FOUR NUTS ON ONE END OF THE AXLE COME OFF THE BOLTS, DAMAGE TO THE BRAKE HYDRAULIC LINE OR THE PARKING BRAKE CABLE CAN OCCUR.

Rischio: OCCURRENCE OF ANY OF THESE CONDITIONS CAN RESULT IN A LOSS OF BRAKING CAPABILITY AND POSSIBLE ACCIDENT.

Rimedio del costruttore: DEALERS WILL INSPECT AND, IF NEEDED, INSTALL NEW BOLTS. IF ANY OF THE FASTENERS ARE DISCONNECTED, THE PARKING BRAKE AND ABS COMPONENTS WILL BE INSPECTED AND SERVICED.

Difetto: THE BOLTS THAT ATTACH THE FRONT UPPER CONTROL ARMS TO THE FRAME MOUNTING BRACKETS CAN LOOSEN AND FRACTURE AT ONE OF THE BOLT HOLES CAUSING SUBSTANTIAL NEGATIVE CAMBER AND STEERING PULL TO THE AFFECTED SIDE.

Rischio: IF THE DRIVER'S SIDE BRACKET FRACTURED AT BOTH BOLT HOLES, THE STEERING CONTROL ARM CAN CONTACT THE STEERING COLUMN SHAFT AND RESULT IN A LOSS OF STEERING CONTROL INCREASING THE POTENTIAL FOR AN ACCIDENT.

Rimedio del costruttore: DEALERS WILL INSPECT THE TORQUE LEVELS OF THE FOUR UPPER CONTROL ARM MOUNTING BOLTS, AND IF ANY ARE LOOSE, THE BRACKETS WILL BE INSPECTED FOR DAMAGE. IF DAMAGE IS PRESENT, IT WILL BE REPAIRED.

Rimedio del costruttore: DEALERS WILL INSPECT THE REAR BRAKE LINES, AND IF NECESSARY, REPLACE A SECTION OF THE REAR BRAKE LINES IF IT IS LEAKING. ALSO THE RUBBER SHIELD ON THE LINE WILL BE INSPECTED TO VERIFY THAT IT IS PROPERLY LOCATED AND IT WILL BE SECURED WITH AN ADDITIONAL WORM-DRIVE TYPE CLAMP.

Difetto: AN UNUSED POWER SEAT HARNESS CONNECTOR IS POSITIONED ON THE RUBBER FLOOR MAT UNDER THE SEAT. IF THE VEHICLE IS OPERATED IN COLD WEATHER IN AREAS THAT HAVE LARGE AMOUNTS OF SALT USED FOR SNOW AND ICE CONTROL, A PUDDLE OF SALTWATER CAN ACCUMULATE ON THE RUBBER FLOOR MATS, REPEATEDLY WETTING THE CONNECTOR. THIS WILL RESULT IN CORROSION OF THE CONNECTOR, CAUSING A CURRENT TO FLOW BETWEEN THE TERMINALS WITHOUT TRIPPING THE CIRCUIT BREAKER.

Rischio: IF THIS OCCURS, CURRENT FLOW CAN HEAT THE CONNECTOR ANDRELEASE FUMES INTO THE PASSENGER COMPARTMENT, AND CAN RESULT IN A VEHICLE FIRE.

Rimedio del costruttore: DEALERS WILL REMOVE THE UNUSED CONNECTOR AND INSTALL A SEALED HEAT SHRINK CAP OVER THE AFFECTED WIRES.

Difetto: ON CERTAIN PICKUP TRUCKS, PASSENGER VEHICLES, SPORT UTILITY VEHICLES, AND MOTOR HOMES CHASSIS, THE SPEED CONTROL DEACTIVATION SWITCH MAY, UNDER CERTAIN CONDITIONS, LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN.

Rischio: THIS COULD RESULT IN AN UNDERHOOD FIRE.

Rimedio del costruttore: DEALERS WILL INSTALL A FUSED WIRING HARNESS. OWNERS OF THE PASSENGER CARS INCLUDED IN THIS CAMPAIGN WILL BE INSTRUCTED TO RETURN THEIR VEHICLES TO THEIR DEALERS TO HAVE THE SPEED CONTROL DEACTIVATION SWITCH DISCONNECTED AS AN INTERIM REPAIR. AS SOON AS REPAIR PARTS ARE AVAILABLE (EXPECTED OCTOBER 2007), OWNERS WILL BE INSTRUCTED TO RETURN TO THE DEALERS FOR INSTALLATION OF A FUSED WIRING HARNESS. THE RECALL BEGAN ON AUGUST 13, 2007, AND MAILING COMPLETED BY SEPTEMBER 19, 2007. OWNERS MAY CONTACT FORD AT 1-888-222-2751.

Difetto: INCORRECT INSTRUMENT PANEL WIRING ASSEMBLIES IN SOME VEHICLES WILL NOT ACTUATE THE "ANTI-LOCK" BRAKE WARNING LIGHTS.

Rischio: THE VEHICLES DO NOT MEET THE SPECIFICATIONS OF FMVSS 105.THE DRIVER WOULD NOT BE AWARE WHEN THE ANTI-LOCK BRAKE SYSTEM IS MALFUNCTIONING.

Rimedio del costruttore: MODIFY THE WIRE ASSEMBLY TO ALLOW ACTUATION OF THE ANTI-LOCK BRAKE WARNING LIGHTS.

Difetto: VEHICLE DESCRIPTION: CERTAIN 1996-1999 FORD CROWN VICTORIA POLICE, FLEET, NATURAL GAS, AND 1996-1999 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT WERE PRODUCED WITH A LOWER CONTROL ARM BALL JOINT CONTAINING A ONE PIECE BEARING; AND 1990-1996 FORD CROWN VICTORIA POLICE, FLEET, AND NGV VEHICLES AND 1990-1996 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT HAVE BEEN SERVICED WITH EITHER A BALL JOINT CONTAINING THE ONE-PIECE BEARING OR A FRONT LOWER CONTROL ARM CONTAINING A BALL JOINT WITH A ONE-PIECE BEARING. THE ONE-PIECE BEARING WITHIN THE LOWER CONTROL ARM BALL JOINT CAN WEAKEN SLOWLY DURING USE AND EVENTUALLY CRACK. THIS COULD RESULT IN SEPARATION OF THE BALL AND CAP OF THE JOINT, ALLOWING THE CONTROL ARM TO DROP TO THE GROUND.

Rischio: IF THIS OCCURS WHILE THE VEHICLE IS MOVING, REDUCED STEERING CONTROL COULD OCCUR, INCREASING THE RISK OF A CRASH.

Rimedio del costruttore: DEALERS WILL REPLACE THE LOWER CONTROL ARM BALL JOINTS (2).

Difetto: THE REAR BRAKE LINES HAVE INADEQUATE CLEARANCE BETWEEN THE BRAKE TUBE AND THE VEHICLE UNDERBODY IN THE AREA OF THE LEFT REAR WHEEL OPENING.

Rischio: INADEQUATE CLEARANCE CAN CAUSE ABRASION OF THE BRAKE LINEAND A LEAK CAN DEVELOP, RESULTING IN LOSS OF BRAKE FLUID TO THE REAR BRAKESYSTEM AND INCREASED STOPPING DISTANCES.

Rimedio del costruttore: REPAIR ANY BRAKE LINES THAT HAVE AN INDICATION OF CONTACT OR HAVE THE POTENTIAL FOR CONTACT WITH THE BODY OF THE VEHICLE. RELOCATE LINES, IF NECESSARY.

Difetto: GLASS ELEMENT THAT SEPARATES ELECTRONIC CIRCUITRY FROM PRESSURIZED FUEL MAY LOOSEN AND CREATE AN OPENING THAT COULD ALLOW PRESSURIZED FUEL TO ENTER BODY OF SENSOR.

Rischio: UNDER THESE CONDITIONS OF SEAL DETERIORATION, THE HOUSINGCOVER WOULD NOT CONTAIN FUEL, CAUSING A FUEL LEAK WHICH, IN THE PRESENCE OF ASOURCE OF IGNITION, COULD RESULT IN A FIRE.

Rimedio del costruttore: INSTALL NEW OPTICAL SENSORS.