Ford Club Wagon

Difetto: THE PARKING BRAKE SYSTEMS MAY NOT HOLD THE VEHICLES ON A 20% GRADE WITH FOOT PEDAL EFFORTS OF 125 POUNDS OR LESS. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC BRAKE SYSTEMS."

Rischio: THE VEHICLE MAY ROLL AFTER BEING PARKED INCREASING THE RISK OF A VEHICLE ACCIDENT.

Rimedio del costruttore: DEALERS WILL ADJUST THE PARKING BRAKE SYSTEM ON THE AFFECTED VEHICLES.

Difetto: ON THE INVOLVED VEHICLES, THE STEERING TIE ROD AND LINK ASSEMBLIES WITH ADJUSTING SLEEVE CLAMPS MAY HAVE BEEN IMPROPERLY MANUFACTURED. THE CLAMPS CONTAIN A SHARP DIE MARK WHICH COULD CAUSE THE CLAMP TO FRACTURE WHEN THE CLAMP BOLT IS TIGHTENED TO SPECIFICATIONS. THE CLAMP COULD BREAK AND CAUSE SEPARATION OF THE TIE ROD ADJUSTING SLEEVES.

Rimedio del costruttore: THE DEALER WILL REPLACE THE STEERING TIE ROD ADJUSTING SLEEVE AND CLAMP ASSEMBLY, FREE OF CHARGE, ON ALL AFFECTED VEHICLES.

Difetto: ON THE INVOLVED VEHICLES, TEMPERED GLASS MAY HAVE BEEN INSTALLED IN THE REAR DOORS INSTEAD OF LAMINATED GLASS. THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 217, "BUS WINDOW RETENTION AND RELEASE". ONE PURPOSE OF THE STANDARD IS TO MINIMIZE THE LIKELIHOOD OF OCCUPANTS BEING EJECTED FROM A BUS IN THE EVENT OF A COLLISION.

Rimedio del costruttore: DEALER WILL INSTALL LAMINATED GLASS IN PLACE OF TEMPERED GLASS IN THE REAR DOOR, WITHOUT CHARGE TO OWNER.

Difetto: THESE TRANSMISSIONS MAY CONTAIN IMPROPERLY MANUFACTURED PARKING PAWL ACTUATING RODS. CONSEQUENTLY, THE UNHARDENED CAM SURFACE OF THESE RODS CAN ALLOW THE ROD TO DEFORM DURING USE WITH RESULTANT INCREASE IN SHIFT EFFORTS AND DIFFICULTY IN RELEASING THE PARKING PAWL AND ENGAGING THE PARKING GEAR.

Rimedio del costruttore: DEALER WILL REPLACE THE TRANSMISSION PARKING PAWL ACTUATING ROD WITHOUT CHARGE TO OWNER.