Ford Bronco Ii

Difetto: ALUMINUM WHEELS MAY HAVE BEEN INSTALLED WITH IMPROPER LUG NUTS.

Rischio: WHEEL COULD BECOME LOOSE OR EVEN SEPARATE FROM THE HUBAND AXLE ASSEMBLY WHILE THE VEHICE IS IN MOTION.

Rimedio del costruttore: CHANGE TAPERED STYLE LUG NUTS TO SHORT SHANK STYLE LUG NUTS.

Difetto: WIRING FOR THE POWER LUMBAR SEAT SYSTEM WAS ROUTED DIRECTLY BENEATH THE SEAT CUSHION SPRINGS AND MAY BE ABRADED BY THE SPRINGS.

Rischio: THIS COULD RESULT IN A SHORT CIRCUIT WHICH MAY CREATESUFFICIENT HEAT TO START A FIRE IN THE SEAT CUSHION PAD AND/OR TRIM COVER.

Rimedio del costruttore: INSTALL A FUSE WITHIN THE POWER LUMBAR ELECTRICAL CIRCUIT.

Difetto: THE ELECTRONIC ENGINE CONTROL WIRING HARNESS INSULATION MAY BE DAMAGED DUE TO COPPER SPIKES PRODUCED DURING THE WELDING OF ITS WIRES. THIS CREATES A POTENTIAL FOR A SHORT CIRCUIT BETWEEN THE WIRES WHICH ENERGIZE THE FUEL PUMP, CAUSING SOME FUEL INJECTORS TO OPEN, DISCHARGING FUEL INTO THE ENGINE. CONSEQUENCE OF DEFECT: FUEL DISCHARGED INTO THE ENGINE WOULD EVENTUALLY LEAK THROUGH THE EXHAUST SYSTEM TO THE GROUND. THIS COULD RESULT IN A FIRE IF A SOURCE OF IGNITION IS PRESENT.

Rimedio del costruttore: REPAIR WIRING HARNESS, CHECK ENGINE AND CATALYST FOR DAMAGE.

Difetto: COMPONENTS IN THE LOCKING HUBS WERE IMPROPERLY HEAT-TREATED AND MAY CRACK OR FRACTURE UPON ENGAGEMENT OF THE FRONT DRIVE AXLES. THE BROKEN COMPONENT ON THE LEFT FRONT WHEEL MAY BECOME JAMMED AGAINST THE NUT.

Rimedio del costruttore: CAM ASSEMBLIES IN FRONT WHEEL AUTOMATIC LOCKING HUBS WILL BE REPLACED.