Mitsubishi Eclipse

Defekt: Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2006-2009 Eclipse vehicles manufactured April 20, 2005, to February 13, 2009, and 2007-2009 Eclipse Spyder vehicles manufactured December 23, 2005, to February 13, 2009. Due to corrosion inside the antil-lock brake system (ABS) unit, one or more of the internal valves may seize. In a braking event that uses the ABS, a seized valve would increase brake pedal travel and reduce braking ability.

Risiko: A sudden reduction of braking performance may increase the risk of a crash.

Herstellerabhilfe: MMNA will notify owners, and dealers will inspect, flush and clean the ABS hydraulic unit using high grade brake fluid, free of charge. If the inspection shows that the valves may seize, the ABS unit will be replaced. The recall began on July 21, 2015. Owners may contact MMNA customer service at 1-888-648-7820. MMNA's number for this recall is SR-15-004.

Defekt: ON CERTAIN PASSENGER VEHICLES, THE METAL FORMING PART OF THE FRONT CROSSMEMBER MAY HAVE BEEN IMPROPERLY STAMPED RESULTING IN THE METAL BECOMING THINNER IN THE CROSS-SECTION THAN SPECIFIED. THIS COULD, OVER TIME, RESULT IN BREAKAGE OF THE CROSSMEMBER.

Risiko: BREAKAGE OF THE CROSSMEMBER MAY ALLOW SEPARATION OF THE PASSENGER SIDE LOWER CONTROL ARM, WHICH MAY RESULT IN THE LOSS OF STEERING CONTROL INCREASING THE RISK OF A CRASH.

Herstellerabhilfe: DEALERS WILL INSPECT AND REPLACE THE CROSSMEMBER FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 21, 2006. OWNERS MAY CONTACT MITSUBISHI AT 888-648-7820.

Defekt: ON CERTAIN VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS, THE KEY LOCK CABLE WAS IMPROPERLY MANUFACTURED AND MAY NOT ALLOW THE CABLE END TO LOCK INTO THE FLOOR SHIFTER MECHANISM. THIS CAN RESULT IN THE INTERLOCK SYSTEM TO BECOME INOPERATIVE AND ALLOW THE IGNITION KEY TO BE REMOVED WITHOUT THE GEARSHIFT MECHANISM BEING PLACED IN THE PARK POSITION.

Risiko: IF THE DRIVER DOES NOT SHIFT TO PARK BEFORE REMOVING THE KEY AND FAILS TO ENGAGE THE PARKING BRAKE, THE VEHICLE COULD ROLL AND A CRASH COULD OCCUR.

Herstellerabhilfe: DEALERS WILL INSPECT THE IGNITION INTERLOCK CABLE AND REPLACE IT IF NECESSARY. THE RECALL BEGAN ON NOVEMBER 20, 2006. OWNERS MAY CONTACT MITSUBISHI AT 1-888-648-7820.

Defekt: CERTAIN PASSENGER VEHICLES MAY HAVE BEEN FITTED WITH A DEFECTIVE BRAKE BOOSTER ASSEMBLY.

Risiko: THE BOOSTER BODY COULD SEPARATE DUE TO IMPROPER CRIMP JOINTS, RESULTING IN A TOTAL LOSS OF BRAKE SYSTEM PERFORMANCE, WHICH COULD RESULT IN A CRASH.

Herstellerabhilfe: DEALERS WILL INSPECT AND REPAIR THE BRAKE BOOSTER ASSEMBLY FREE OF CHARGE. OWNERS WERE NOTIFIED BY TELEPHONE ON MAY 24, 2005, TO STOP DRIVING THEIR VEHICLES AND ARRANGEMENTS WERE MADE FOR A LOANER VEHICLE. OWNERS MAY CONTACT MITSUBISHI AT 1-800-222-0037.

Defekt: ON CERTAIN PASSENGER VEHICLES, ONE OF FOUR SEALS INSIDE THE MASTER CYLINDER MAY HAVE BEEN INSTALLED IMPROPERLY. AS A RESULT, THE MASTER CYLINDER MAY UNEXPECTEDLY BY-PASS HYDRAULIC BRAKING FORCE PRESSURE AND ALLOW A LONGER THAN NORMAL PEDAL STROKE.

Risiko: SHOULD THIS CONDITION OCCUR, THE BRAKING DISTANCE REQUIRED TO STOP THE VEHICLE MAY INCREASE AND COULD LEAD TO A VEHICLE CRASH.

Herstellerabhilfe: DEALERS WILL REPLACE THE MASTER CYLINDER ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN JUNE 28, 2005. OWNERS MAY CONTACT MITSUBISHI AT 1-888-648-7820.

Defekt: ON CERTAIN PASSENGER VEHICLES, THE FUEL RETURN LINE HOSE FITTING ON THE ELECTRIC FUEL PUMP MAY BE IMPROPERLY MOLDED.

Risiko: BREAKAGE COULD RESULT IN A LEAKAGE OF FUEL AND IN THE PRESENCE OF AN IGNITION SOURCE, IT COULD RESULT A FIRE.

Herstellerabhilfe: DEALERS WILL REPLACE THE FUEL PUMP. THE RECALL BEGAN ON JULY 26, 2004. OWNERS SHOULD CONTACT MITSUBISHI AT 1-800-222-0037.

Defekt: VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.

Risiko: THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH. THIS CAMPAIGN SUPERCEDES MMC'S PREVIOUS SAFETY RECALL CAMPAIGN, SEE 99V-066.

Herstellerabhilfe: DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT INTRUSION OF MOISTURE.

Defekt: VEHICLE DESCRIPTION: PASSENGER VEHICLES. LOCKUP OF THE TRANSFER CASE CAN OCCUR DUE TO INSUFFICIENT LUBRICATION.

Risiko: THIS CONDITION CAN CAUSE A LOSS OF VEHICLE CONTROL, INCREASING THE RISK OF A CRASH.

Herstellerabhilfe: DEALERS WILL INSPECT THE VEHICLES FOR ADEQUACY OF THE TRANSFER CASE OIL VOLUME, TRANSFER CASE OIL LEAKAGE, AND OPERATIONAL DEGRADATION OF THE TRANSFER CASE MECHANISM. IF OIL VOLUME IS INSUFFICIENT, THE APPROPRIATE AMOUNT OF OIL WILL BE ADDED. IF THERE IS TRANSFER CASE OIL LEAKAGE, AFFECTED COMPONENTS WILL BE REPLACED. IF THE TRANSFER CASE SHOWS OPERATIONAL DEGRADATION, THE TRANSFER CASE WILL BE REPLACED.

Defekt: THE HEADREST GUIDE BRACKET WAS IMPROPERLY WELDED TO THE SEAT BACK FRAME ON THE PASSENGER SIDE SEAT BACK ASSEMBLIES ONLY.

Risiko: THE HEADREST SUPPORT BRACKET CAN BREAK, INCREASING THE RISK OF PERSONAL INJURY.

Herstellerabhilfe: DEALERS WILL REPLACE THE PASSENGER SEAT BACK ASSEMBLY WITH A NEW ASSEMBLY.

Defekt: THE FUEL TANK GASKETS FOR THE FUEL PUMP AND/OR GAUGE UNIT GASKET COULD HAVE BEEN INCORRECTLY INSTALLED ALLOWING FUEL OR FUMES TO ESCAPE.

Risiko: IF AN IGNITION SOURCE WERE PRESENT, THE FUEL LEAKAGE COULD RESULT IN A FIRE.

Herstellerabhilfe: DEALERS WILL INSPECT THE FUEL TANK AND IF THE GASKETS ARE FOUND TO BE LEAKING, REPLACE THE FUEL TANK, CAPS AND GASKETS.

Defekt: THE HEADLAMP SUPPORT PANEL CAN DEVELOP A FATIGUE CRACK WHERE THE ANTI-LOCK BRAKE SYSTEM (ABS) HYDRAULIC UNIT IS ATTACHED, ALLOWING THE HYDRAULIC UNIT TO FALL DOWN.

Risiko: LOSS OF BRAKING CAN RESULT IF THE ABS HYDRAULIC UNIT FALLS. THIS CAN RESULT IN A VEHICLE ACCIDENT.

Herstellerabhilfe: DEALERS WILL CONNECT THE ABS HYDRAULIC UNIT ATTACHMENT POINT AT A RIGID PORTION OF THE HEADLAMP SUPPORT PANEL WITH A BRACKET AND REINFORCE THE HEADLAMP SUPPORT PANEL BY ADDING A BACK PLATE.

Defekt: WIRING HARNESS FOR THE HEADLAMPS MAY BREAK DUE TO THE STRESS CREATED BY THE HEADLAMP POP UP DEVICES.

Risiko: BREAKAGE OF THE WIRING HARNESS CAUSES LOSS OFHEADLAMP ILLUMINATION WHICH COULD HAVE A POTENTIAL FOR AN ACCIDENT.

Herstellerabhilfe: HEADLAMP WIRING HARNESS ROUTING WILL BE MODIFIED AND DAMAGED WIRES REPAIRED.

Defekt: DILUTED PRIMER MAY HAVE BEEN USED ON THE WINDSHIELD OPENING FLANGES PRIOR TO WINDSHIELD GLASS INSTALLATION WHICH WOULD NOT PROVIDE THE RETENTION REQUIRED BY FMVSS 212.

Risiko: WINDSHIELDS WOULD NOT PREVENT EJECTION OF VEHICLEOCCUPANTS DURING A VEHICLE CRASH, WHICH CAUSES SERIOUS INJURIES AND FATALITIES.

Herstellerabhilfe: REPLACE WINDSHIELDS, ASSOCIATED PARTS, AND PRIMER.

Defekt: OPERATION OF SUNROOF IN "NON-STANDARD" MANNER MAY CAUSE MALE HINGE DISENGAGEMENT FROM THE ROOF HINGE RECEIVER.

Risiko: THE SUNROOF GLASS COULD DETACH FROM THE ROOF AND RESULT IN INJURY TO OCCUPANTS OR PERSONS IN THE VICINITY, ESPECIALLY IF THIS OCCURS WHILE THE VEHICLE IS IN MOTION.

Herstellerabhilfe: REPLACE MALE HINGE WITH A MODIFIED VERSION TO INCREASE ROOF HINGE RECEIVER RETENTION ABILITY.