Ford Escort

Defekt: VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH THE S/R OPTION. THE S/R OPTION INCLUDES, AMONG OTHER FEATURES, A 5-SPEED MANUAL TRANSMISSION. ON THESE VEHICLES, THE TRANSMISSION SHIFT PATTERN IS NOT DISPLAYED IN THE OCCUPANT COMPARTMENT IN VIEW OF THE DRIVER. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK, AND TRANSMISSION BRAKING EFFECT."

Risiko: THE DRIVER MAY NOT BE AWARE OF THE TRANSMISSION POSITION OF THE VEHICLE.

Herstellerabhilfe: OWNERS WILL BE PROVIDED WITH AN ADHESIVE BACKED PLAQUE CONTAINING THE SHIFT PATTERN, ALONG WITH MATERIALS AND INSTRUCTIONS FOR LOCATING AND AFFIXING THE PLAQUE TO THE VEHICLE CENTER CONSOLE, JUST FORWARD OF THE SHIFT LEVER. OWNERS WILL ALSO BE ADVISED THAT THEIR DEALER CAN AFFIX THE PLAQUE IF THEY PREFER.

Defekt: ON CERTAIN PASSENGER VEHICLES, THE INTEGRATED AIR BAG MONITOR (IABM) CAN BE CONTAMINATED WITH WATER OR OTHER LIQUIDS AND COULD EXPERIENCE INTERNAL ELECTRICAL SHORTING.

Risiko: THIS MAY, IN TURN, CAUSE THE AIR BAG READINESS LIGHT TO ILLUMINATE AND IN VERY RARE OCCURRENCES, AIR BAG DEPLOYMENT, MELTED WIRING, OR FIRE MAY OCCUR.

Herstellerabhilfe: DEALERS WILL INSTALL THE SHIELD OVER THE IABM AND APPLY NYOGEL GREASE TO THE CONNECTOR. OWNER NOTIFICATION BEGAN FEBRUARY 11, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-866-436-7332.

Defekt: TWO BOLTS THAT ATTACH THE PASSENGER SIDE AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM MODULE TO THE INSTRUMENT PANEL ARE MISSING. IN THE EVENT OF A FRONTAL IMPACT, THE MODULE CAN COME OUT OF THE INSTRUMENT PANEL.

Risiko: THIS WOULD NOT RESTRAIN THE PASSENGER AND WOULD RESULT IN AN INCREASED RISK OF INJURY.

Herstellerabhilfe: DEALERS WILL INSPECT AND, IF NECESSARY, INSTALL AND TORQUE TO SPECIFICATION THE MOUNTING BOLTS FOR THE PASSENGER SIDE AIR BAG.

Defekt: VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH 1.9L ENGINES, BUILT AT THE HERMOSILLO ASSEMBLY PLANT AND ORIGINALLY SOLD OR CURRENTLY REGISTERED IN ARIZONA. CRACKS CAN DEVELOP IN THE FUEL TANK NEAR THE HEAT SHIELD ATTACHMENT RESULTING IN FUEL LEAKAGE IF THE CRACKS GO THROUGH THE FUEL TANK WALL.

Risiko: FUEL LEAKAGE IN THE PRESENCE OF AN IGNITION SOURCE CAN RESULT IN A VEHICLE FIRE.

Herstellerabhilfe: DEALERS WILL REMOVE THE HEAT SHIELD ATTACHMENTS. THIS WILL NOT AFFECT HEAT SHIELD LOCATION OR FUNCTION, AS THE ATTACHMENTS ARE INTENDED TO KEEP THE SHIELD IN PLACE UNTIL THE FUEL TANK IS INSTALLED IN THE VEHICLE. AFTER INSTALLATION, THE FUEL TANK STRAPS RETAIN THE HEAT SHIELD.

Defekt: THE DRIVER SIDE AIR BAG MODULE CAN HAVE AN INADEQUATELY WELDED INFLATOR CANISTER.

Risiko: IN THE EVENT OF A COLLISION, THE WELD SEAM CAN SEPARATE, CAUSING THE AIR BAG TO FAIL TO DEPLOY PROPERLY AND HOT GASES TO BE EXPELLED FROM THE BACK OF THE STEERING WHEEL. THIS CAN RESULT IN AN INCREASED RISK OF PERSONAL INJURY FROM THE HOT GASES AND THE AIR BAG FAILURE.

Herstellerabhilfe: DEALERS WILL INSTALL A NEW AIR BAG MODULE.

Defekt: THE LOCK PLATE OF THE DRIVER SIDE INBOARD SEAT TRACK ADJUSTERS WERE MANUFACTURED WITH AN UNAUTHORIZED MODIFICATION TO THE FABRICATION PROCESS WHICH CAUSES THE SEAT NOT TO FULLY ENGAGE IN CERTAIN SEATING POSITIONS NEAR THE MID-POINT OF THE SEAT TRACK TRAVEL.

Risiko: IN THE EVENT OF A CRASH THE SEAT CAN MOVE, WHICH WOULD RESULT IN REDUCED OCCUPANT PROTECTION.

Herstellerabhilfe: DEALERS WILL REPLACE THE DRIVER SIDE INBOARD SEAT TRACK.

Defekt: INTERFERENCE OCCUR BETWEEN BOLT THAT SECURES A FUEL LINE SHIELD TO THE LOWER PORTION OF THE DASH PANEL AND THE ACCELERATOR PEDAL.

Risiko: THIS COULD CAUSE THE ACCELERATOR PEDAL TO STICK AT THE WIDE OPEN THROTTLE POSITION AND RESULT IN LOSS OF CONTROL WITH THE RISK OF A VEHICLE ACCIDENT.

Herstellerabhilfe: CUT OFF EXTRA LENGTH OF BOLT THAT PROTRUDES ABOVE SURFACE OF WELD NUT TO PREVENT INTERFERENCE.

Defekt: SPECIAL PRIMER THAT PROMOTES THE BONDING OF A URETHANE ADHESIVE TO THE GLASS WAS NOT APPLIED TO THE WINDSHIELDS BEFORE INSTALLATION.

Risiko: OMISSION OF THE PRIMER COULD CAUSE THE WINDSHIELD NOT TOBE PROPERLY ADHERED TO BODY, AND VEHICLE WOULD NOT COMPLY WITH FMVSS 212.

Herstellerabhilfe: REMOVE AND PROPERLY INSTALL WINDSHIELD USING SPECIAL PRIMER.

Defekt: THE FORWARD OUTBOARD PEDESTAL OF THE SEAT TRACK OF DRIVER'S SEAT MAY BE SUSCEPTIBLE TO FATIGUE FRACTURE.

Risiko: THIS COULD RESULT IN A LIMITED DEGREE OF ROCKING MOTIONOF THE DRIVERS SEAT ASSEMBLY UPON ACCELERATION OR DECELERATION, WHICH COULDCAUSE AN ACCIDENT.

Herstellerabhilfe: INSTALL A REINFORCEMENT ON ALL MODELS AND A NEW SEAT TRACK AS NECESSARY

Defekt: THE THROTTLE LEVER MAY NOT RETURN TO IDLE POSITION DUE TO MISALIGNMENT OF THE AIR CONDITIONER SHUT OFF SWITCH TO THE THROTTLE LEVER PIN. CONSEQUENCE OF DEFECT: A JAMMED THROTTLE COULD RESULT IN A LOSS OF ACCELERATOR CONTROL, WITHOUT PRIOR WARNING, AND AN ACCIDENT.

Herstellerabhilfe: ADJUST SHUTOFF SWITCH AND ASSURE PROPER ALIGNMENT TO THROTTLE LEVER PIN.

Defekt: EXTERNAL CRACKS ABOVE THE NUMBER 3 CYLINDER (1984 MODELS) OR ROCKER ARM COVER GASKETS SPLITTING (1985 MODELS) COULD ALLOW OIL TO LEAK ONTO THE EXHAUST MANIFOLD.

Risiko: ENGINE OIL LEAKING ONTO A HOT EXHAUST MANIFOLD COULDRESULT IN AN ENGINE COMPARTMENT FIRE.

Herstellerabhilfe: REPLACE CRACKED CYLINDER HEADS (1984 MODELS); REPLACE ROCKER ARM COVER GASKETS (1985 MODELS).

Defekt: SEAT FRAME STRUCTURE COULD SEVER FRONT SEAT BELTS IF VEHICLE IS INVOLVED IN AN ACCIDENT, DEPENDING ON FORCE OF IMPACT.

Herstellerabhilfe: DEALER WILL INSTALL A MOLDED SPACER BETWEEN REINFORCEMENT PLATES AND LOWER DECORATIVE PLASTIC COVER.

Defekt: DURING A CRASH BARRIER TEST, THE RUBBER HOSE CONNECTING THE FUEL TANK AND THE METAL FILLER PIPE VENT TUBE WAS CUT, RESULTING IN FUEL LEAKAGE. THE INVOLVED VEHICLES FAIL TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".

Herstellerabhilfe: DEALER WILL INSTALL A BRACE BETWEEN THE RIGHT SIDE REAR QUARTER PANEL AND THE BODY SIDE RAIL TO IMPROVE FUEL TANK IMPACT RESISTANCE.

Defekt: THE DIAPHRAGM MATERIAL OF THE MECHANICAL FUEL PUMPS MAY DETERIORATE AND ALLOW THE DIAPHRAGM TO RUPTURE.

Risiko: FUEL PUMPED THROUGH THE RUPTURED DIAPHRAGM AND OUT OFTHE VENT OPENING COULD RESULT IN A FIRE.

Herstellerabhilfe: INSTALL NEW MECHANICAL FUEL PUMPS WITH IMPROVED DIAPHRAGM MATERIAL AND REVISE WIRING FOR ELECTRIC FUEL PUMP CIRCUITS.

Defekt: THE PORTION OF THE ROOF ABOVE FRAME (RAIL) TO WHICH THE SHOULDER BELT IS ANCHORED MAY HAVE A SLOT THAT CAN COMPROMISE THE STRENGTH OF THE SHOULDER BELT ANCHOR UNDER CERTAIN SEVERE LOADS. (THE SUSPECT AREA IS NOT VISIBLE.) CONSEQUENTLY, SOME VEHICLES INCLUDED IN THIS RECALL MAY NOT MEET THE 3000 POUND ANCHORAGE STRENGTH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 210, "SEAT BELT ASSEMBLY ANCHORAGES".

Herstellerabhilfe: THE DEALER WILL INSPECT AND, IF NECESSARY, REINFORCE THE ROOF RAIL INNER PANEL SURROUNDING THE DRAINAGE HOLE AT NO COST TO OWNER.

Defekt: ON CERTAIN VEHICLES, THE RIGHT AND LEFT HAND REAR BRAKE BACKING PLATE ATTACHMENT BOLTS MAY NOT HAVE BEEN TIGHTENED TO THE CORRECT SPECIFICATIONS. BACKING PLATE BOLTS MAY NOT BE ABLE TO WITHSTAND THE LOADS EXPERIENCED DURING TRUCK SHIPMENT. IF THE BOLTS LOOSEN FROM THE SPINDLE DURING OPERATION, BACKING PLATE MOVEMENT MAY RESULT IN WEAKENING OR PREMATURE WEAR OF ONE OR BOTH REAR BRAKE TUBES. THIS COULD LEAD TO LOSS OF BRAKE FLUID.

Herstellerabhilfe: DEALER WILL INSPECT AND TIGHTEN THE BOLTS TO THE PROPER SPECIFICATIONS. REAR BRAKE TUBES WILL BE REPLACED, IF NECESSARY, AT NO CHARGE TO OWNER.

Defekt: SCREW THAT CONNECTS THE SEAT BACK FRAME TO THE RECLINER MECHANISM MAY BREAK.

Herstellerabhilfe: THE ATTACHMENT SCREW ON THE DRIVER"S SEAT WILL BE REPLACED BY ONE OF A LARGER DIAMETER.

Defekt: ON CERTAIN VEHICLES, METAL FASTENERS THAT WERE USED TO SECURE THE CARPETING TO THE FLOOR PAN MAY HAVE ACCIDENTALLY PENETRATED THE TOP OF THE FUEL TANK. THIS WOULD RESULT IN A SLIGHT FUEL LEAK.

Herstellerabhilfe: DEALER WILL INSPECT VEHICLES FOR PENETRATION OF THE FUEL TANK BY CARPET FASTENERS. ANY LEAKING FUEL TANKS WILL BE REPLACED AND THE FLOOR PAN WILL BE SEALED, WITHOUT CHARGE TO OWNERS.

Defekt: SOME OF THE INVOLVED VEHICLES WERE PRODUCED WITH AN ENGINE COMPARTMENT WIRE ASSEMBLY THAT MAY HAVE BEEN ROUTED ABOVE THE AIR CONDITIONING SUCTION HOSE. THIS HOSE MAY PUSH UP ON THE WIRING HARNESS CAUSING IT TO CONTACT THE HOOD PROP ROD BRACKET ATTACHING BOLT. THIS COULD LEAD TO PENETRATION OR CHAFING OF THE WIRING INSULATION.

Herstellerabhilfe: DEALER WILL INSPECT AND, IF NECESSARY, CORRECT THE WIRING HARNESS ROUTING AT NO CHARGE TO OWNER.

Defekt: FUEL MAY POSSIBLY TRAVEL THROUGH THE SPEED CONTROL VACUUM LINES AND INTO THE SPEED CONTROL ACTUATION DEVICE (SERV0). THE FUEL CAN DAMAGE SEALS IN THE ACTUATOR SERVO AND ALLOW VACUUM LEAKS. SUCH A LEAK COULD ACTIVATE THE SPEED CONTROL WITHOUT ANY ACTION ON THE PART OF THE DRIVER. THIS WOULD CAUSE THE VEHICLE TO GRADUALLY ACCELERATE.

Herstellerabhilfe: THE VACUUM CHECK VALVE AND HOSE ASSEMBLY WILL BE REPLACED AND THE SPEED CONTROL SERVO WILL BE REPLACED IF IT HAS BEEN DAMAGED.