Ford F-450 Sd

Defect: Ford Motor Company (Ford) is recalling certain 2021 F-350, F-450, F-550, and F-600 vehicles equipped with dual rear wheels and front wheel hub extenders. The front wheel hub extenders may be improperly attached to the front rotor hub assemblies, which could result in separation of the wheels and wheel extenders from the vehicle.

Risk: A detached wheel and wheel extender can increase the risk of a crash.

Manufacturer fix: Owners are instructed not to drive their vehicles until the torque of the wheel extender nuts can be verified. Dealers will inspect and tighten the front wheel hub extender nuts, free of charge. Owner notification letters were mailed on June 18, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 21S26.

Defect: Ford Motor Company (Ford) is recalling certain 2025-2026 F-550 SD, F-450 SD, F-350 SD, F-250 SD, and 2025 F-150 vehicles. The Instrument Panel Cluster (IPC) may fail at startup.

Risk: An instrument panel display that does not show critical information, such as warning lights or vehicle speed, increases the risk of a crash.

Manufacturer fix: The instrument panel cluster software will be updated by a dealer or through an over-the-air (OTA) update, free of charge. Owner notification letters were mailed September 5, 2025. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 25S88.

Defect: Ford Motor Company (Ford) is recalling certain 2021-2024 Bronco, F-150, 2021-2024 Edge, 2022-2025 Escape, F-250, F-350, F-450, F-550, F-600, 2022-2024 Expedition, 2022-2025 Transit, 2021-2023 Mach-E, 2024 Ranger, Mustang, 2021-2023 Lincoln Nautilus, 2022-2024 Navigator, and 2023-2024 Corsair vehicles. A software error may cause the rearview camera image to delay, freeze, or not display when the vehicle is in reverse.

Risk: A frozen or missing rearview camera image can reduce the driver's view behind the vehicle, increasing the risk of a crash.

Manufacturer fix: The accessory protocol interface module (APIM) software will be updated by a dealer or through an over-the-air update, free of charge. This will be a phased campaign, with the remedy becoming available in different phases based on model and model years. Interim letters notifying owners of the safety risk were mailed on June 26, 2025. Additional letters will be mailed once the final remedy is available on each phase. Owner notification letters were sent on October 8, 2025. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 25S49.

Defect: Ford Motor Company (Ford) is recalling certain 2023-2024 F-250, F-350, and F-450 vehicles. Water may enter the Tailgate Park Assist Sensor Interface Module (TPASIM) and cause the rearview camera image to display intermittently or appear blue or black.

Risk: A rearview camera image that does not display can decrease the driver's visibility, increasing the risk of injury or crash.

Manufacturer fix: Dealers will replace the tailgate top camera, wire harness, TPASIM module, and update the Image Processing Module A (IPMA) software, free of charge. Owner notification letters were mailed August 6, 2025. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 24S66.

Defect: Ford Motor Company (Ford) is recalling certain 2021 F-150 and 2020-2021 F-250, F-350, F-450, and F-550 Super Duty vehicles. During manufacturing, the windshield may not have been properly bonded to the vehicle, allowing it to detach in a crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 212, "Windshield Mounting."

Risk: In the event of a crash, if the windshield separates from the vehicle, it can increase the risk of injury.

Manufacturer fix: Ford will notify owners, and dealers will remove and reinstall the windshield, free of charge. The recall began April 16, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 21C06.

Defect: Ford Motor Company (Ford) is recalling certain 2018-2019 F-250, F-350 and F-450 Super Duty trucks. The Daytime Running Lights (DRL) may not dim when the headlight switch is moved into the "On" position. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."

Risk: DRL that cannot dim may reduce the visibility of other drivers, increasing the risk of a crash.

Manufacturer fix: Ford has notified owners, and dealers will reprogram the Body Control Module (BCM) software, free of charge. The recall began November 25, 2019. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19C10.

Defect: Ford Motor Company (Ford) is recalling certain 2019 F-150, Super Duty F-250, F-350, F-450, and F-550 vehicles. Due to a poor electrical connection, the rearview camera may intermittently display a blank or distorted image. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."

Risk: A rearview camera that displays a blank or distorted image can reduce the drivers view of what is behind the vehicle, increasing the risk of a crash.

Manufacturer fix: Dealers will replace the rearview camera, free of charge. Owner notification letters were mailed June 2, 2022. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 20C19.

Defect: Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pressure switch to determine if it is from the range of defective switches and if required, remove the pressure switch assembly and put a plug in the port where the PTO switch had been installed. This switch was never being utilized. This will be done free of charge. The recall is expected to begin in mid-July 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.

Risk: The leaking oil may soak into the thermal blanket covering the exhaust, which when combined with heat from exhaust, may result in an increased risk of fire.

Manufacturer fix: Iowa Mold Tooling Co., Inc. will notify owners, and dealers will install a new pressure switch kit that moves the switch away from the exhaust system, free of charge. The recall began on July 28, 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.

Defect: FORD IS RECALLING CERTAIN MODEL YEAR 2011 FORD F-150, F-250, F-350, F-450, F-550, EDGE, AND LINCOLN MKX TRUCKS MANUFACTURED FROM OCTOBER 25, 2010, THROUGH NOVEMBER 20, 2010. THESE VEHICLES WERE INSPECTED USING INTEGRATED DIAGNOSTIC SYSTEM (IDS) THAT HAD A CUSTOM SOFTWARE ROUTINE TO READ THE SUSPECT BODY CONTROL MODULE (BCM) SERIAL NUMBER. BASED ON THE SERIAL NUMBER THE BCM WAS EITHER NOT AFFECTED OR REPLACED. THE CUSTOM SOFTWARE ROUTINE WAS NOT READING THE CORRECT SET OF CHARACTERS, AND WAS NOT ABLE TO IDENTIFY A BCM THAT REQUIRED REPLACEMENT AFFECTED BCMS MAY HAVE THE POTENTIAL FOR AN INTERNAL SHORT.

Risk: IF AN ELECTRICAL SHORT DEVELOPS, AN OVERHEATING CONDITION MAY OCCUR WHICH COULD RESULT IN A VEHICLE FIRE.

Manufacturer fix: DEALER WILL INSPECT THE BODY CONTROL MODULE AND IF NECESSARY REPLACE IT FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MARCH 7, 2011. OWNERS MAY CONTACT FORD MOTOR COMPANY CUSTOMER RELATIONSHIP CENTER AT 1-866-436-7332.

Defect: FORD IS RECALLING CERTAIN MODEL YEAR 2011 F-150, F-250, F-350, F-450, F-550, EDGE AND LINCOLN MKX VEHICLES. DURING A SIX-DAY PRODUCTION PERIOD, THE SUPPLIER OF THE BODY CONTROL MODULE MANUFACTURED MODULES THAT MAY HAVE THE POTENTIAL FOR AN INTERNAL SHORT.

Risk: IF AN ELECTRICAL SHORT DEVELOPS, AN OVERHEATING CONDITION MAY OCCUR WHICH CAN RESULT IN AN UNATTENDED VEHICLE FIRE.

Manufacturer fix: DEALER WILL REPLACE THE BODY CONTROL MODULE IF NECESSARY FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 11, 2011. OWNERS MAY CONTACT FORD AT 1-866-436-7332.

Defect: Palfleet Truck Equipment Company, LLC (Palfleet) is recalling certain model year 2009-2013 Ford F-350, F-450, and F-550 super duty vehicles modified by Palfleet and equipped with certain Muncie Power Products PTO Assemblies. In the affected vehicles, oil may leak from the PTO pressure switch onto a thermal blanket covering the exhaust.

Risk: The leaking oil may soak into the thermal blanket covering the exhaust, which when combined with heat from exhaust, may result in an increased risk of fire.

Manufacturer fix: Palfleet will notify owners, and dealers will install a new pressure switch kit that moves the switch away from the exhaust system, free of charge. The recall began on July 29, 2014. Owners may contact Palfleet customer service at 1- 502-376-2458.

Defect: Godwin Manufacturing Company, Inc. (Godwin) is recalling certain model year 2010 Ford F-450; 2011 Ford F-550; 2012 Ford F-350 and 2013 F-350 Super Duty trucks modified by Godwin and equipped with certain Muncie Power Products PTO Assemblies. In the affected vehicles, oil may leak from the PTO pressure switch onto a thermal blanket covering the exhaust.

Risk: The leaking oil may soak into the thermal blanket covering the exhaust, which when combined with heat from exhaust, may result in an increased risk of fire.

Manufacturer fix: Godwin will notify owners, and dealers will install a new pressure switch kit that moves the switch away from the exhaust system, free of charge. The recall began October 28, 2014. Owners may contact Godwin customer service at 1-800-892-0181.

Defect: ON CERTAIN TRUCKS EQUIPPED WITH A 6.4L DIESEL ENGINE, EXCESSIVE TEMPERATURES IN THE DIESEL PARTICULATE FILTER IN THE EXHAUST SYSTEM MAY RESULT FROM EXCESS HYDROCARBONS IN THE EXHAUST.

Risk: LACK OF POWER OR ROUGH OPERATION, UNUSUAL NOISES FROM THE ENGINE OR EXHAUST, WHITE SMOKE FROM THE EXHAUST, AND POTENTIALLY A VISIBLE FLAME OUT THE TAILPIPE CAN OCCUR.

Manufacturer fix: DEALERS WILL REPROGRAM THE POWER TRAIN CONTROL MODULE. THE RECALL BEGAN ON APRIL 3, 2007. OWNERS MAY CONTACT FORD AT 1-800-392-3673.

Defect: VEHICLE DESCRIPTION: TRUCKS EQUIPPED WITH COMMERCIAL TRUCK TIRES THAT HAVE STEEL CORDS IN THE TIRE SIDEWALL. THE VALVE STEMS MAY HAVE BEEN TORN OR DAMAGED DURING ASSEMBLY AND COULD LEAK CAUSING SIDEWALL DAMAGE.

Risk: IF NOT MAINTAINED, COULD RESULT IN A SIDEWALL ZIPPER FAILURE. A ZIPPER FAILURE DURING INFLATION OF A DAMAGED TIRE COULD RESULT IN INJURY TO SOMEONE NEAR THE TIRE.

Manufacturer fix: DEALERS WILL INSPECT THE VALVE STEMS FOR LEAKAGE, AND WILL REPLACE BOTH THE VALVE STEM AND THE TIRE IF LEAKAGE IS PRESENT. OWNER NOTIFICATION BEGAN MARCH 28, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-800-392-3673.

Defect: VEHICLE DESCRIPTION: MEDIUM DUTY TRUCKS BUILT ON A 165" WHEEL BASE, 4X2 CHASSIS-CABS EQUIPPED WITH A 6.81 ENGINE, 5 SPEED MANUAL TRANSMISSION AND OPTIONAL 5.38:1 REAR AXLE RATIO. THE TWO-PIECE DRIVE SHAFT CAN BE DAMAGED IF THE VEHICLE IS DRIVEN AT SPEEDS IN EXCESS OF 80 MILES PER HOUR.

Risk: THIS CONDITION CAN RESULT IN UNDERBODY DAMAGE OR FOR THE DRIVE SHAFT TO SEPARATE FROM THE VEHICLE.

Manufacturer fix: DEALERS WILL REPLACE THE DRIVE SHAFT ON THESE VEHICLES.

Defect: ON CERTAIN TRUCKS EQUIPPED WITH SPEED CONTROL, GASOLINE OR NATURAL GAS ENGINES, THE SPEED CONTROL DEACTIVATION SWITCH MAY OVERHEAT.

Risk: OVERHEATING COULD RESULT IN SMOKE OR BURN AND AN UNDERHOOD FIRE.

Manufacturer fix: DEALERS WILL INSTALL A FUSED WIRING HARNESS INTO THE SPEED CONTROL SYSTEM FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 7, 2006. OWNERS MAY CONTACT FORD AT 1-866-436-7332. (NOTE: ALSO SEE RECALLS 05V017 AND 05V388)