Ford E150

Defect: Mobility Works (WMK Inc.) is recalling certain model year 2006-2014 Ford E150, E250, and E350 vans modified by Mobility Works to be equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts manufactured by Ricon Corporation. The platform side plate of the affected wheelchair lifts may crack.

Risk: If the platform side plates crack, the lift platform can separate from the lift and come to rest against the vehicle's lift door. When the doors are opened, the platform may fall out, increasing the risk of injury to the lift operator.

Manufacturer fix: Mobility Works will notify owners, and Ricon will supply supplemental platform support bumpers. Any platform that has already started cracking will be replaced, free of charge. The recall began on November 10, 2014. Owners may contact Mobility Works customer service at 1-800-769-8267 or Ricon customer service at 1-800-322-2884.

Defect: ON SOME OF THE INVOLVED VEHICLES, THE SHIFT ROD IN THE TRANSMISSION MAY NOT BE PROPERLY SEATED IN THE RETENTION GROMMET OF THE STEERING COLUMN SHIFT LEVER ASSEMBLY. IF THE SHIFT ROD WERE TO DISENGAGE, THE DRIVER COULD NOT SELECT THE PROPER TRANSMISSION FUNCTION WHICH WOULD CREATE THE POTENTIAL FOR UNEXPECTED MOVEMENT OF THE VEHICLE.

Manufacturer fix: DEALER WILL INSPECT THE SHIFT ROD ATTACHMENT AND MAKE SURE IT IS PROPERLY SEATED AT NO COST TO OWNER.

Defect: CERTAIN VEHICLES WERE EQUIPPED WITH FRONT BRAKE HOSE ASSEMBLIES THAT WERE INCORRECTLY MANUFACTURED BY THE SUPPLIER. THESE ASSEMBLIES, BOTH RH AND LH, WERE INCORRECTLY BUILT WITH THE FITTINGS MISORIENTED BY 90 DEGREES. THIS COULD CAUSE CHAFING OF THE BRAKE HOSE THROUGH CONTACT WITH THE ADJACENT TIRE DURING FULL TURNS. CONTINUED CHAFING COULD RESULT IN A BRAKE FLUID LEAK.

Manufacturer fix: DEALER WILL INSPECT BOTH FRONT BRAKE HOSES AND, IF NECESSARY, REPLACE ONE OR BOTH HOSES AT NO CHARGE.

Defect: THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.

Manufacturer fix: DEALER WILL REPLACE THE SUSPECT BRAKE RETAINING PIN.

Defect: THE SHIFT SELECTOR REACTION SPRINGS MAY BE DEFORMED AS A RESULT OF IMPROPER INSTALLATION OF SELECTOR LEVERS DURING COLUMN BUILDUP. THUS THE LEVER MAY NOT BE ABLE TO BE MOVED INTO THE INSERT DETENTS LOCATED IN THE STEERING COLUMN ASSEMBLY. THIS COULD PREVENT THE "PARK" GEAR FROM BEING ENGAGED.

Manufacturer fix: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE SHIFT SELECTOR REACTION SPRING WITHOUT CHARGE TO OWNER.