Ford Aerostar

Dealers WILL Install A NEW Accelerator Cable.

Dealers WILL Install A Jumper Harness WITH A Relay Which WILL RE-Route AND Activate ALL A2 Accessories Through THE Relay.

Owners WILL BE Mailed A Supplementary Label Containing THE Correct REAR TIRE Information AND Instructions FOR Installing THE Label ON Their Vehicles. IF Owners Prefer, Their Dealer CAN Install THE Label FOR THEM.

Dealers WILL Install A Lower Profile MINI-Spare TIRE ON THE Existing MINI-Spare Wheel. THE NEW TIRE WILL Allow THE MINI-Spare TO BE Installed WITH Appropriate Clearances IN THE Underbody Spare TIRE Carrier.

Dealers WILL Install A Fused Jumper Harness IN THE FUEL PUMP Ground Circuit THAT WILL BE Installed AT THE FUEL PUMP Inertia SHUT-OFF Switch.

Dealers WILL Install A NEW Transfer CASE REAR Output Shaft Bushing AND AN Aluminum Driveshaft WILL BE Installed.

Dealers WILL Install A NEW Transfer CASE REAR Output Shaft Bushing AND AN Aluminum Driveshaft WILL BE Installed.

Replace Noncomplying SOFA BAR WITH BAR THAT Meets Requirements.

Repair THE Transmission WITH A NEW PARK PAWL.

Install NEW Design Master Cylinder Incorporating A Redesigned SEAL.

Dealers WILL Replace THE FUEL TANK, Regardless OF Mileage, Through March 31, 2002. THIS Coverage WILL ONLY BE FOR Structural Cracks AT THE TOP OF THE TANK AND WILL NOT Include Other Damage Caused BY AN Accident OR ROAD Debris.

Replace SEAT PAWL Assembly WITH A Revised Design Assembly.

Installation OF A Relay WITH Wires OF Gauge Adequate TO Protect THE Circuit.

Replace THE GAS Cylinder-TO-BODY Attachment BALL Studs.

Install Plastic Pivot Cover; Replace Belts AS Necessary.

Replace FUEL Tanks AS Necessary.

Reinforce Suspect WELD Locations AND Modify TO Prevent WELD Failure.

Aimco WILL Reimburse Consumers/Installers FOR THE COST OF Replacement Rotors AND Installation. Consumers ARE Requested TO Return TO THE Location Where THE Rotors WERE Originally Purchased/Installed FOR Replacement.

Install A Revised Design Grommet.